Creating And Naming Static Vlans; Purpose; Commands; Set Vlan - Enterasys D-Series Cli Reference Manual

Creating and Naming Static VLANs

Purpose

To create a new static VLAN, or to enable or disable existing VLAN(s).

Commands

For information about...

set vlan

set vlan name
clear vlan
clear vlan name
set vlan
Use this command to create a new static IEEE 802.1Q VLAN, or to enable or disable an existing
VLAN.
Syntax
set vlan {create | enable | disable} vlan-list
Parameters
create | enable |
disable
vlan‐list
Defaults
None.
Mode
Switch command, read‐write.
Usage
Once a VLAN is created, you can assign it a name using the set vlan name command described in
"set vlan name" on page 9‐6.
Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device assumes that the
Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 1 and 4093. The VLAN IDs of 0 and 4094 and
higher may not be used for user‐defined VLANs.
Examples
This example shows how to create VLAN 3:
D2(su)->set vlan create 3
Creates, enables or disables VLAN(s).
Specifies one or more VLAN IDs to be created, enabled or disabled.
Creating and Naming Static VLANs
Refer to page...
9-5
9-6
9-6
9-7
Enterasys D-Series CLI Reference 9-5