12.2.9.17 client-class
Use this command to identify an DHCP client class. Using this command to give a set of client class
properties a name, allows you to assign properties to all DHCP clients within the class rather than
configuring each client separately. This command also enables DHCP class configuration mode.
client-class name
Syntax Description
name
Command Syntax of the "no" Form
The "no" form of this command deletes a client class name:
no client-class name
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
None.
Example
This example shows how to assign "clientclass1" as a client class name in the "localpool" address
pool:
Matrix>Router1(config)#ip dhcp pool localpool
Matrix>Router1(config-dhcp-pool)#client-class clientclass1
Configuring Dynamic Host Configuration Protocol (DHCP)
Specifies a name for a DHCP client class.
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
12-133