Enterasys Matrix 2G4072-52 Configuration Manual page 1038

IP Configuration Command Set
Configuring Load Sharing Network Address Translation (LSNAT)
12.2.8.4 real
Use this command to add a real LSNAT server to a server farm and to enable LSNAT real server
configuration mode.
real ip-address port number
Syntax Description
ip-address
port number
NOTE: For backwards compatibility, entering a port number is optional for TCP session
persistence only. However, the recommended procedure is to always configure a port
number for a real server.
Command Syntax of the "no" Form
The "no" form of this command removes the server from the server farm:
no real ip-address
Command Type
Router command.
Command Mode
SLB Server Farm Configuration mode: Matrix>Router1(config-slb-sfarm)#
Command Defaults
If not specified, port 0 will be applied.
Example
This example shows how to add a real server at 10.1.2.3 to the server farm named "httpserver" and
to configure the port number to be used for the service provided by this server.:
Matrix>Router1(config)#ip slb serverfarm httpserver
Matrix>Router1(config-slb-sfarm)#real 10.1.2.3 port 80
Matrix>Router1(config-slb-real)#
12-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a server IP address.
Specifies a port number for this server.
Note that all real servers in the same server farm should be
configured to use the same port.