Enterasys Matrix 2G4072-52 Configuration Manual page 1112

Routing Protocol Configuration Command Set
Configuring RIP
13.2.2.6 timers
Use this command to adjust RIP routing timers determining the frequency of routing updates, the
length of time before a route becomes invalid, and the interval during which routing information
regarding better paths is suppressed.
timers basic update-seconds invalid-seconds holdown-seconds flush-seconds
Syntax Description
basic
update-seconds
invalid-seconds
holdown-seconds
flush-seconds
Command Syntax of the "no" Form
The "no" form of this command clears RIP timer parameters:
no timers basic
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router1(config-router)#
Command Defaults
None.
Example
This example shows how to set RIP timers to a 5 second update time, a 10 second invalid interval,
a 20 second holdown time, and a 60 second flush time:
Matrix>Router1(config)#router rip
Matrix>Router1(config-router)#timers basic 5 10 20 60
13-10 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a basic configuration for RIP routing timers.
Specifies the rate (seconds between updates) at which
routing updates are sent. Valid values are 0 to 4294967295.
Specifies the interval (in seconds) after which a route is
declared invalid. Valid values are 1 to 4294967295.
Specifies the interval (in seconds) during which routing
information regarding better paths is suppressed. Valid
values are 0 to 4294967295.
Specifies the interval (in seconds) after which a route is
deleted. Valid values are 0 to 4294967295.