Manual Numeric Command Operation On The Tool Offset Screen (M, T) - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.

2.3.1.5 Manual Numeric Command Operation on the TOOL OFFSET Screen (M, T)

To execute a manual numeric command on the TOOL OFFSET screen, first change the mode from
usual data setting to manual numeric command. The M and T commands can be executed by
screen operation in manual numeric command mode.
(1) Changing the mode from usual data setting to
(2) Execution the manual numeric command ... Execute this after operation (1) above.
(Note) The manual numeric command operation is the same as the operation for the POSITION
(3) Returning the mode from manual numeric command to usual data setting
1) The cursor is displayed in first parenthesis
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
manual numeric command
In the usual data setting mode, the cursor is
displayed in the data setting field.
It is not displayed in manual numeric command
mode. By checking this difference, make sure that
the mode has changed. Change the mode by the
following operations:
Set M (Manual) in the first parenthesis
pair of the setting field.
1) This operation is necessary regardless
of the command (M, T).
INPUT
Press the key. The mode
changes to manual numeric command.
1) Data is cleared from the setting field. The
cursor is also cleared from the screen.
1) Press the address key corresponding to the command. The corresponding command value
display field is highlighted, and the manual numeric command input mode is activated. To
execute the tool function, input
2) Input the specified numerics from keys.
INPUT
3) Press the key. The command is executed.
screen. See "2.2.1.3 Manual Numeric Value Command" in 'POSITION' of 'MONITOR'
screen for details.
Press the key. The usual data setting
mode returns.
pairs. After this, usual data setting is enabled.
search engine
2.3 (II). Tool Offset (M system)
T . To execute the miscellaneous function, input
I - 83
M .