Inputting Auxiliary Axis Parameter Data - Mitsubishi Electric MELDAS C6 Instruction Manual

2.6.1.6 Inputting Auxiliary Axis Parameter Data

Auxiliary axis parameter data that has been output by auxiliary axis parameter output operation can
be input.
(1) Inputting auxiliary axis parameter data
Set the data type to auxiliary axis
parameter.
# ( 2 8 ) DATA (
Press the
1) Data input is started.
2) When all data through the end has been
(Note 1) If MR-J2-CT is not connected, "E01 SETTING ERROR" will occur and input will not be
(Note 2) Whether to input the auto-tuning parameters depends on the "#7 ATU" parameter settings in
(Note 3) Which parameters can be input depends on the setting of "#7 ATU" parameter.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
)
INPUT
key.
The contents of input data and message
"DATA IN EXECUTION" are displayed.
input and the end code % (EOR) is read,
data input ends with message "DATA IN
COMPLETE" displayed.
carried out.
the input data and NC data.
#7 ATU in input data
Auto-tuned (0 or 1)
Not auto-tuned (2)
Auto-tuned (0 or 1)
Not auto-tuned (2)
Refer to "2.6.2.7 MR-J2-CT Parameters and N No. Correspondence Table" for details on
auto-tuning target parameters.
search engine
2.6 Data In/Out
28
28
#7 ATU set in NC
Auto-tuned (0 or 1)
Auto-tuned (0 or 1)
Not auto-tuned (2)
Not auto-tuned (2)
I - 139
Auto-tuning
parameter input
Not input
Input (Note 3)
Input (Note 3)
Input (Note 3)