Restrictions - Mitsubishi Electric MELDAS C6 Instruction Manual

6.3 Restrictions

(1) If the MCP alarm "Y02 SYSTEM ALARM" occurs, part of the data will not be coded. Confirm the
data on the display unit.
(Example) Y02 SYSTEM ALARM 0051 0104
In this case, only "Y02" and "0051" are coded and output to the PLC I/F device.
(2) If an alarm without an alarm No. occurs, "0000" will be set in the alarm No. area output to the PLC
I/F device.
(3) If an alarm that does not have an axis name occurs, "0" will be set in the axis name area output to
the PLC I/F device.
(4) Alarms not shown in the code table are not output to the PLC I/F device.
(5) If multiple alarms occur simultaneously, only the alarm with the highest order of priority in the code
table will be output.
(6) The "
(Example) When "P34 G-CODE ERROR" occurs, the output will be as follows.
The code to be output is "71003400" and output to the PLC interface as follows.
0 1 1 1 0 0 0 1 0 0 0 0 0 0 0 0 0 0 1 1 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Alarm typ
Downloaded from ManualsNet.com
6. Table of Conversion Codes for Error Code Output
" section of the program error "P
search engine
6.3 Restrictions
" is output to the alarm No. area.
Alarm No.
IV - 23
Axis name