Selecting Nc No. And Part System; Selecting From The Pull-Down Menu - Mitsubishi Electric MELDAS C6 Instruction Manual

3.2.1 Selecting NC No. and Part System

When the multiple part systems are applied, the display of various information for one part system
such as counters, modals, etc. can be changed to that for the other part system.
1st part system is selected when the power is turned ON.
When the single part system is applied, part system display cannot be changed.

3.2.1.1 Selecting from the Pull-down Menu

(1) To select the NC
1)
Press the NC select button.
(Ex.) Press M01 .
2)
Select the NC to be displayed
from the pull-down menu.
(EX.) Select "M02".
(Note 1) After the NC is selected, the contents for the 1st part system will be displayed at first.
(Note 2) If there are eight or more NC device names that can be selected, six will appear in the
(Note 3) This function can be used with the MELDAS C64T Version C or higher system.
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.2 NC Monitor Screen (For only the panel computer)
pull-down menu. Press the (Cont.
display the seventh and following devices.
search engine
A pull-down menu to select an NC will appear.
The information for M02 controller are displayed
in the screen.
) button at the very bottom of the pull-down menu to
I - 255