Mitsubishi Electric MELDAS C6 Instruction Manual page 44

(Note 1) If the type is BCD output and a negative number is set, the positive value converted from
(Note 2) If the number of digits specified in the command exceeds the setting range, the most
(5) Other notes on operation
Press address key
Then, press key
in order.
Press the
1) A minus value will be output, but a positive value will display.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
it will be output.
(Example) Manual numeric command
M − 100
significant digit will be lost.
(Example)
M 1234
(1) When a minus command is set:
Before setting the numeric, press the
(Example) If S-150 is specified:
S .
=
!
-
1
key.
INPUT
(2) When manual numeric command operation stops halfway:
If the operation is desired to be stopped before input after pressing the address key, press
any non-numeric key.
(a) If a manual numeric command address-key such as MST is pressed, the previous
operation will stop. In this case, the next manual numeric command sequentially begins.
(b) If an axis address key (X, Y, or Z, etc.) is pressed, the manual numeric command will
stop. In this case, the origin zero or counter zero mode is then entered.
CAN
(c) If the SHIFT keys are pressed, the manual numeric command will stop. In this case,
C.B.
the POSITION screen is blanked.
(d) If one of the following keys is pressed, the operation will not stop:
• Position display function key
=
•
key pressed before a numeric is set (will be processed as a minus command.)
-
•
DEL key when a numeric has been set (The set data will be deleted.)
(3) The macro interruption codes (M96, M97) and subprogram call codes (M98, M99) will not
be processed even if M99 is issued.
(4) No peripheral-speed command is available.
In the constant peripheral speed mode, no command is processed, if specified.
search engine
2.2 Monitor
Output
⇒
M 100
⇒
M 2345
5
1
=
(minus) key.
-
5 0
MONITOR
I - 29
Most significant digit is lost.