Mitsubishi Electric MELDAS C6 Instruction Manual page 495

Error No.
P297
P298
P300
P301
P360
P380
P381
P382
P383
P384
P385
P390
Downloaded from ManualsNet.com
Details
ADR-A ERR.
The user macro does not use address A
as a variable.
PTR OP (MACRO)
User macro G200‚ G201‚ or G202 was
specified during tape or MDI operation.
VAR. NAME ERROR
The variable names have not been
commanded properly.
VAR. NAME DUPLI
The name of the variable has been
duplicated.
NO PROG.MIRR.
A mirror image (G50.1 or G51.1)
command has been issued though the
programmable mirror image specifica-
tions are not provided.
NO CORNER R/C
A command was issued for corner
rounding or corner chamfering though
there are no such specifications.
NO ARC R/C SPC
Corner rounding or chamfering was
specified in the arc interpolation block
although corner chamfering/corner
rounding II is unsupported.
CORNER NO MOVE
The block next to corner rounding/
chamfering is not a movement
command.
CORNER SHORT
In the corner rounding or chamfering
command‚ the movement distance was
shorter than the value in the correspond-
ing command.
CORNER SHORT
When the corner rounding or chamfering
command was input‚ the movement
distance in the following block was
shorter than the length of the corner
rounding or chamfering.
G0 G33 IN CONR
A block with corner rounding/chamfering
was given during G00 or G33 modal.
NO GEOMETRIC
A geometric command was issued
though there are no geometric specifica-
tions.
search engine
7. List of Alarms
7.10 Program Error
• Review the program.
• Review the program.
• Review the variable names in the program
and correct them.
• Correct the program so that the name is not
duplicate.
• Check the specifications.
• Check the specifications.
• Remove the corner rounding or chamfering
command from the program.
• Check the specifications.
• Replace the block succeeding the corner
rounding/chamfering command by G01
command.
• Make the corner rounding or chamfering
less than the movement distance since this
distance is shorter than the corner rounding
or chamfering.
• Make the corner rounding or chamfering
less than the movement distance since this
distance in the following block is shorter
than the corner rounding or chamfering.
• Review the program.
• Check the specifications.
IV - 79
Remedy