Mitsubishi Electric MELDAS C6 Instruction Manual page 104

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.
(2) TOOL LIFE data screen
GROUP
#1 to #10
TOOL NO.
ST
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
The TOOL LIFE data displays tool data in group units. If the number of lines displayed exceeds
one screen area, press the
The data to control the life of a group of tools can be displayed and set.
Display item
Group number of the tools which carry out tool life
control.
These are data setting numbers, not magazine pot
numbers.
Number given to each tool. A maximum of 400 tool
numbers can be registered depending on the
specifications.
Tool Status
0: Unused tool.
1: Used tool.
2: Normal life tool.
3: Tool error 1 tool
4: Tool error 2 tool
(Note)
search engine
2.3 (II). Tool Offset (M system)
NEXT BACK
or
Explanation
Tool status
Open to machine manufacturer
Normally, it is set to 0 when the tool is replaced
with a new tool.
It is set to 1 when actual cutting is begun.
It is set to 2 when the use data (time, count)
exceeds the life data.
3 and 4 depend on the machine
manufacturer specifications.
I - 89
key to scroll the screen.
1 to 99999999
1 to 99999999
Setting range