Tool Offset Data Setting; Tool Offset Data Clear; Tool Offset Data Setting Modes (Absolute And Incremental) - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.

2.3.1.1 Tool Offset Data Setting

(1) For type I
(2) For type II
(3) If the
(4) If tool offset data is set with an offset memory number not contained in the displayed offset
(5) The offset memory number displayed in # ( ) can be consecutively incremented or decreased
(6) To set the incremental mode, enter

2.3.1.2 Tool Offset Data Clear

(1) Clear in display screen units

2.3.1.3 Tool Offset Data Setting Modes (Absolute and Incremental)

(1) Absolute value setting
Enter A in # (
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
To set tool offset data, set the offset memory number in # ( ) and offset data in DATA ( ), then
INPUT
press the input key.
To set tool offset data, set the offset memory number in # ( ) and offset data in the setting area
corresponding to LENG, WEAR, RADIUS and WEAR, then press the
INPUT
key is pressed after the offset memory number and tool offset data are set, the
tool offset data set in the offset memory number position is displayed, the offset memory
number in the setting area # ( ) is incremented by one, and the contents of DATA ( )
disappear. At the time, the cursor moves to the right end of the same setting field as the input
time.
memory numbers, the screen changes to the screen corresponding to the setup offset memory
number when the INPUT
tool offset data set in the offset memory number position is displayed.
by one by pressing the
In incremental mode, the set data is added to the data indicated in the display area. To cancel
the incremental mode, enter
set. (For details, see Sections 6.3.1.3.)
20 sets of tool offset data (10 sets for type II) are displayed on one screen. To clear all displayed
offset data, press the SHIFT
Change to the absolute value setting mode as
follows:
), then press the input key.
# ( A) DATA ( )
search engine
2.3 (II). Tool Offset (M system)
key is first pressed. When the
or key.
P in # ( ), then press the
O in # ( ), then press the
CAN
key, then press the and
C.B
#A: ABS is displayed in reverse video indicating that
the absolute value setting mode is valid.
I - 78
INPUT
key.
INPUT key is pressed again, the
INPUT
key.
INPUT
key; the absolute mode is
INPUT keys.