Mitsubishi Electric MELDAS C6 Instruction Manual page 110

(Note) Selection of inch/metric unit
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
When setting value of "#1041 I_inch" is changed‚ the unit of length is changed after the power
is turned ON again.
Among parameters concerning length‚ following items are not changed automatically‚ therefore
change the setting values to match the new unit system when the unit system is changed.
Tool compensation amount (Tool length compensation amount‚ tool wear compensation
amount and tool nose compensation amount)
Workpiece coordinate offset
Machining #8004 SPEED
parameter
#8005 ZONE r
#8006 ZONE d
#8009 DSC. ZONE
#8010 ABS. MAX.
#8011 INC. MAX.
#8012 G73n
Axis parameter #8204 OT-CHECK-N
#8205 OT-CHECK-P
#8206 TOOL CHG.P
#8209 G60 SHIFT
Barrier data #8300 to #8306
Basic specification #1084 RadErr
parameter
"#8004 SPEED" is 10 inches/min unit for the inch system.
The parameter input setting units are as follows.
Input unit
Machine constant:mm
"#1003 iunit"
"#1040 M_inch"=0
B
C
search engine
2.4 Parameters
#8013 G83n
#8016 G71 MINIMUM
#8017 G71 DELTA-D
#8018 G84/G74n
#8027 Toler-1
#8028 Toler-2
#8051 G71 THICK
Linear axis "#1017 rot"=0
Machine constant:inch
"#1040 M_inch"=1
0.001 mm
0.0001 mm
I - 95
#8052 PULL UP
#8053 G73 U
#8054
#8056 G74 RETRACT
#8057 G76 LAST-D
Rotary axis
"#1017 rot"=1
0.0001 inch 0.001°
0.00001 inch 0.0001°
W