Mitsubishi Electric MELDAS C6 Instruction Manual page 490

Error No.
P152
P153
P155
P156
P157
P158
P170
P172
P173
Downloaded from ManualsNet.com
Details
I.S.P NOTHING
In interference block processing during
execution of a tool radius compensation
(G41 or G42) or nose radius
compensation (G41‚ G42‚ or G46)
command‚ the intersection point after
one block is skipped cannot be
determined.
I.F ERROR
An interference error has arisen while the
tool radius compensation command (G41‚
G42) or nose R compensation command
(G41‚ G42‚ G46) was being executed.
F-CYC ERR (CC)
A canned cycle command has been
issued in the tool radius compensation
mode.
BOUND DIRECT
At the start of G46 nose radius
compensation‚ the compensation direction
is undefined if this shift vector is used.
SIDE REVERSED
During G46 nose R compensation‚ the
compensation direction is inverted.
ILLEGAL TIP P.
During G46 nose R compensation‚ the tip
point is illegal (other than 1 to 8).
NO CORR. NO.
The compensation number (DOO‚ TOO‚
HOO) command was not given when the
tool radius compensation (G41‚ G42‚
G43‚ G46) command was issued.
Alternatively‚ the compensation number
is larger than the number of sets in the
specifications.
G10 L-No. ERR
(G10 L-number error)
The L address command is not correct
when the G10 command is issued.
G10 P-No. ERR
(G10 compensation error)
When the G10 command is issued‚ a
compensation number outside the
permitted number of sets in the
specifications has been commanded for
the compensation number command.
search engine
7. List of Alarms
7.10 Program Error
• Review the program.
• Review the program.
• The tool radius compensation mode is
established when a canned cycle
command is executed and so the tool
radius compensation cancel command
(G40) should be issued.
• Change the vector to that with which the
compensation direction is defined.
• Exchange with a tool having a different tip
point number.
• Change the G command to that which
allows inversion of the compensation
direction (G00‚ G28‚ G30‚ G33‚ or G53).
• Exchange with a tool having a different tip
point number.
• Turn on the G46 inversion error avoidance
parameter.
• Change the tip point number to a legal one.
• Add the compensation number command
to the compensation command block.
• Check the number of compensation
number sets and correct it to a compensa-
tion number command within the permitted
number of compensation sets.
• Check the address L-Number of the G10
command and correct the number.
• First check the number of compensation
sets and then set the address P
designation to within the permitted number
of sets.
IV - 74
Remedy