Parameters - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
(3) Incrementation when using one tool with multiple compensation Nos.
With this function, each registered T No. (tool No. + compensation No.) has independent USED
data, so the count for a tool using multiple compensation Nos. is incremented for each
compensation No.
Thus, life management for that tool's USED data is carried out with the total of the USED data
for each compensation. Because of this, when only one # No. is looked at on the screen, the
tool status (ST) may be 2 (life-reached tool), although that tool's USED data has not yet reached
the life of the tool.
The total of the currently selected tool's USED data appears in "TOTAL" of the <CHOSEN
TOOL> column on Page 1.
Example of the screen display when using multiple compensation Nos.
∗ The life of tool 101010 is the total usage

2.3.5.3 Parameters

The tool life management specifications will differ according to parameter "#1096 T_Ltype" and
"#1106 Tcount". Confirm the explanation for the relevant setup parameter data item.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
• Time method (life: 100000 min.)
time of #1 to #3.
search engine
2.3 (I). Tool Offset (L system)
• Count method (life: 100000 times)
∗ The life of tool 101010 is the total count of
#1 to #3.
I - 71