Outputting Parameter Data - Mitsubishi Electric MELDAS C6 Instruction Manual

2.6.2.3 Outputting Parameter Data

Parameter data which is set and displayed on the screen can be output. The output operation can
be made also during automatic operation.
The output tape length varies with the number of axes and parameter numerics. For the three-axis
specification, this length is 40 to 50m. The following data is output:
• User parameters (Machining parameters, control parameters, axis parameters)
• Data input/output parameters (I/O BASE PARAM, I/O DEVICE PARAM)
• All setup parameters
• Internal parameter data (absolute position internal data)
(Note 1) The TOOL OFFSET, TOOL REGISTRATION, TOOL LIFE, and WORK OFFSET data are
(Note 2) To output the parameters related to MELSECNET/10, set as "#(99) DATA ( ALL2)".
(1) Outputting parameter data
Set the data type to parameter.
# ( 3 ) DATA ( T E S T 1 )
Press the
1) Output to parameter data is started. The
2) After the end code % (EOR) is output,
(2) Output tape format
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
not output.
key.
INPUT
message "DATA OUT EXECUTION" are
displayed.
data output ends with the message
"DATA OUT COMPLETE" displayed.
search engine
2.6 Data In/Out
I - 146