Memory Search - Mitsubishi Electric MELDAS C6 Instruction Manual

2.2.4.1 Memory Search

Any work program is called from the machining programs registered in memory before work.
Set the program number to be called, the sequence number, and block number. Set the tape
search setting area to 0. The initial state when power is turned on is memory search.
Set the program number to be
called. Set the sequence number
and block number as required.
(Example)
To call O1234 N20 block,
O ( 1 2 3 4 ) N ( 2 0 ) - (
COL. (
Press the
1) A search is started.
2) When
(Note 1) If one of the following operations is executed in the EDIT screen after memory search, the
(Note 2) One block which the control unit executes in one automatic start cycle can be searched in
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
) TAPE (0)
key.
INPUT
the specified
number, sequence number, and
block number are found, SEARCH
COMPLETE message is displayed.
The found numbers are displayed
in O and N. Data in the found
block is displayed in the work
program display area.
system enters a status in which nothing is being searched. Operation is disabled at this
time. In this case, execute the search again.
• Deleting the program being searched.
• Deleting the sequence number for which the search was being executed.
• Deleting the block corresponding to the block number for which the search was being
executed.
this case. The block with ; (EOB) or sequence number only is not regarded as a one cycle
execution block. Axis movement command or control command such as M, S, or T is
contained in it.
search engine
2.2 Monitor
)
program
I - 38