Realtime Wave Screen (For Only The Panel Computer) - Mitsubishi Electric MELDAS C6 Instruction Manual

3.7 Realtime Wave Screen (For only the panel computer)

Servo data/Spindle data waveform display tool of C64T has two modes;
• The mode to display the waveform at the alarm occurrence. (Available for NC alarm guidance.)
• The mode to display the real time waveform of Servo data and Spindle data.
Refer to "3.6.2 NC Alarm Screen (waveform display)" for the waveform at the alarm occurrence.
This section (3.7) describes the waveform of the real time mode.
During the real time mode, the screen displays the waveform of the synchronous error amount, that is,
the position error amount between the spindle and the tapping axis during synchronous tapping.
1. NC select button
2 Waveform
display area
5.Data selection
menus
6. Function
selection
menus
(Refer to
"(2) Menus")
(1) Display items
Display items
1. NC select
button
2. Waveform
display area
3. Alarm display
column
4. Cursor buttons
5. Data selection
menus
6. Function
selection
menus
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.7 Realtime Wave Screen (For only the panel computer)
M01
The name of the selected NC is displayed.
Press here to display a pull-down menu to select an NC.
The operation method is the same as the NC MONITOR screen.
The servo and spindle data current when the servo and spindle alarm occurred
is displayed.
This display area is also used when setting the various display conditions.
Displays a occurring alarm.
The cursor buttons are used to scroll the waveform display, etc.
(The START/STOP buttons are not used when the data current at the alarm
occurrence is displayed.)
↑ ↓
← →
START STOP : Switches the sampling start or stop.
These menus differ according to the set item, and appear when display data or
a movement target cursor is selected.
These are also used to set and change the value data.
When a function is selected and the menu is pressed, the display will be
highlighted and the function setting will be enabled.
Refer to the next page for explanations on each menu.
search engine
Details
: Use these to select the data item to be set.
: Use these to move the cursor left and right.
I - 289
3.Alarm display column
4.Cursor
buttons