Data Change - Mitsubishi Electric MELDAS C6 Instruction Manual

2.5.3.3 Data Change

A machining program can always be edited
unless it is run in memory mode.
For example, when the data to be edited is
displayed as shown in the right, let's try to
change the
N 7
(1)
Move the cursor to the data to be
replaced.
(2)
Set new data
G03 Y200. J100. ;
1) Each time a character is set the cursor is
2) When data is entered by using the keys,
(3)
After completion of correction,
press the
1) The new data is written into memory.
2) The new data is also displayed with each
3) The cursor is moved to the top of the
4) When the data has been written into
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Y 2 0 0 . ; b lo c k to
G 0 3 Y 2 0 0 . J 1 0 0 . ;
automatically moved one column to the
right.
the message EDITING is displayed.
Note that if the cursor reaches the end of
editing area (left side area for the
small-character mode), the keys are
ignored and the message as "EDIT
(CAN'T REPLACE)" appears.
key.
INPUT
work being both preceded and followed
by space code.
block on the screen.
memory, the EDITING message
disappears.
search engine
2.5 Program
N1 G28 X0 Y0 Z0;
N2 G92 X0 Y0 Z0;
N3 G00 X-300. Y–300.;
N4 G01 X-200. F2000 ;
N5 Y-200.;
N6 X200.;
N7 Y200.;
M02;
%
N1 G28 X0 Y0 Z0;
:
N7 Y 200.;
M02;
%
N7 G03Y200.J100.;
M02;
%
N7 G03 Y200. J100.;
M02;
%
I - 119
EDIT (REP.)
EDIT (REP.)
EDITING