Mitsubishi Electric MELDAS C6 Instruction Manual page 68

(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
(Note 1) If the screen is changed back to the TOOL DATA screen after axis selection (after the
(Note 2) If an axis having an error (reference point return incomplete axis, etc.) is selected, the
(Note 3) For a diameter command, the diameter value is written.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
(4) Select the axis to be measured.
X axis - X
Z axis - Z
Press the address key of
each axis.
The selection is canceled by
pressing the same address
key twice.
Measure the X and Z axes.
X
(5) The data is automatically calculated and written.
(The data is written for the axis shown in highlighted characters.)
INPUT
Confirm that the data has
been written to X and Z of
tool No. "1".
Repeat the above steps for
each tool.
characters are highlighted), the selection is invalidated (the characters are not highlighted).
characters will not be highlighted. An error message will appear.
For a radius command, the radius value is written.
search engine
2.3 (I). Tool Offset (L system)
Z
I - 53