Machining Program Input - Mitsubishi Electric MELDAS C6 Instruction Manual

2.6.1.2 Machining Program Input

To input a user-prepared machining program, perform the following:
(1) To input the program stored in the external memory onto the CNC without changing its number.
Set the data type.
# ( 1 ) DATA (
Press the
1) Data input is started.
2) When normal data input is
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
The program can be input simply by specifying machining program data type #1. Even if the
program number is specified, the number on the external memory takes precedence over that
number.
)
key.
INPUT
The program number being
entered is displayed in the
setting area.
executed to the end and the
EOR code is read, data input is
terminated.
CAUTION
" ; " "EOB" and " % " "EOR" are symbols used for explanation. The actual codes are: For
ISO: "CR, LF", or "LF" and "%".
Programs created on the Edit screen are stored in the NC memory in a "CR, LF" format, but
programs created with external devices such as the FLD or RS-232C may be stored in an
"LF" format.
The actual codes for EIA are: "EOB (End of Block)" and "EOR (End of Record)".
To prevent influence from data omission and data transformation in the communication
circuit, always verify the data after inputting and outputting machining programs.
search engine
2.6 Data In/Out
I - 134