Use Of The Trace Mode - Mitsubishi Electric MELDAS C6 Instruction Manual

2.8.3 Use of the Trace Mode (

To select the trace mode, press the menu key
When the trace mode is selected, the machine position is indicated by a triangle mark. If this tool
mark does not appear, it is because the machine position is outside the screen display range. In
this case, change the display range (explained below) and move the coordinates, or widen the
display range by greatly increasing the scale value.
The machine position is always drawn in the trace mode. The actual movement by automatic or
manual operation is drawn. The machine zero point appears as a
(1) Trace start
Press the menu key
1) The message TRACE EXECU-
2) A tool mark appears at the
3) After this, the machine move-
(2) Trace release
Press the menu key
1) The TRACE EXECUTION mes-
2) The tool mark disappears.
(Note 1) The trace mode can also
(3) Line types in the trace mode
(Note) When high-speed drawing is carried out in the trace mode, the drawing shape becomes
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
TRACE
TION appears, indicating the
trace mode.
machine position.
ment is drawn in the trace mode.
TRACE
sage disappears, indicating that
the trace mode is released.
be released by the follow-
ing operation:
1. Press the function selection
key F0 .
1. Movement by rapid traverse and manual feed: Broken line
2. Movement by cutting feed: Solid line
more deformed as the command speed increases. Correct shapes especially cannot be
drawn during high-speed machine lock. Set the cutting feed to 2000mm/min. or less.
search engine
2.8 Graphics
TRACE
)
TRACE
.
.
.
I - 225
mark.
TRACE EXECUTION
TRACE EXECUTION