Mitsubishi Electric MELDAS C6 Instruction Manual page 489

Error No.
P112
P113
P122
P130
P131
P132
P133
P150
P151
Downloaded from ManualsNet.com
Details
PLANE CHG (CC)
• A plane selection command (G17‚ G18‚
G19) has been issued when the cutter
compensation command (G41‚ G42) or
nose R compensation command (G41‚
G42‚ G46) is issued.
• The plane selection command was
issued when nose radius
compensation is completed‚ there is no
axial movement command after the
G40 command‚ and the compensation
has not been canceled.
ILLEGAL PLANE
The arc command axis is not on the
selected plane.
NO AUTO C-OVR
An automatic corner override command
(G62) has been issued though it is not
included in the specifications.
2nd AUX. ADDR
The 2nd miscellaneous function address
specified in the program does not match
that set by the parameter.
NO G96 SPEC
(No constant peripheral speed)
The constant peripheral speed command
(G96) was issued despite the fact that
such a command does not exist in the
specifications.
SPINDLE S = 0
No spindle speed command has been
specified.
G96 P-No. ERR
An invalid constant peripheral speed
control axis has been specified.
NO C-CMP SPEC
• Even though there were no tool radius
compensation specifications, tool
radius compensation commands (G41
and G42) were issued.
• Even though there were no nose R
compensation specifications, nose R
compensation commands (G41, G42,
and G46) were issued.
G2‚ 3 CMP. ERR
A compensation command (G40‚ G41‚
G42‚ G43‚ G44‚ G46) has been issued in
the arc mode (G02‚ G03).
search engine
7. List of Alarms
7.10 Program Error
• Issue the plane selection command after
the cutter compensation command or nose
radius compensation command has been
canceled (issue axial movement command
after the G40 cancel command).
• Issue arc command on the correctly
selected plane.
• Check the specifications.
• Delete the G62 command from the
program.
• Check and correct the 2nd miscellaneous
function address in the program.
• Check the specifications.
• Change from the constant peripheral speed
command (G96) to the rotation speed
command (G97).
• Review the program.
• Review the parameter specified for the
constant peripheral speed control axis.
• Check the specifications.
• Issue the linear command (G01) or rapid
traverse command (G00) in the compensa-
tion command block or cancel block.
(Set the modal to linear interpolation.)
IV - 73
Remedy