Mitsubishi Electric MELDAS C6 Instruction Manual page 287

(4) When copying machining programs, the O No. (NC unit side) and file name (memory card
Copy source
(NC to card)
Copy
destination
(Card to NC)
(5) MR-J2-CT parameter COPY function
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.4 Data In/Out Screen (For only the panel computer)
side) are determined according to the following rules.
NC unit Copy source
directory input state
Input (selected) Not input
Input (selected) Input (selected) The name designated as the copy destination
Not input
(not selected)
Input (selected) Not input
Input (selected) Input (selected) The machining program with the first O No. in
Not selected
Inputting the MR-J2-CT automatic tuning parameters
Whether to input or ignore the automatic tuning parameters depends on the combination of
the automatic tuning selection parameter (auxiliary axis parameter #7 ATU) input data and NC
unit value.
Table of automatic tuning selection parameter combinations
Selection of input data
automatic tuning
Selected (0 or 1)
Not selected (2)
Selected (0 or 1)
Not selected (2)
(Refer to the correspondence of the MR-J2-CT parameters and N No. explained in the
"MELDAS64 Series MR-J2-CT Link Specifications" (BNP-B3941) for details on the automatic
tuning parameters.)
(Note 1) Some MR-J2-CT parameters are validated only when the power is turned OFF and
ON after inputting the parameter.
(Note 2) When the MR-J2-CT parameters are returned, the auxiliary axis' absolute position
data can also be returned. Note that the data cannot be returned for the rotary axis,
so after turning the power OFF and ON, initialize the auxiliary axis.
If MR-J2-CT parameters backed up with another machine are input, the absolute
position zero points of all auxiliary axes will deviate. Initialize all auxiliary axes after
turning the power OFF and ON.
search engine
Copy
destination File name or O No. after copying
input state
An extension (.prg) is added to the input O
(not selected) No.
file name is used.
Copying is not possible.
The EXECUTE menu is invalid.
The O No. used in the copy source file is
(not selected) used.
the copy source file is used as the O No.
designated as the copy destination and is
stored in the NC unit.
Note that if there are multiple machining
programs in one file, the machining programs
with the second and following O Nos. used in
the file are used as the machining program
No. even after copying.
Copying is not possible.
The EXECUTE menu is invalid.
Selection of NC side
automatic tuning
Selected (0 or 1)
Selected (0 or 1)
Not selected (2)
Not selected (2)
I - 272
Input of automatic turning
parameters
Ignore
Input
Input
Input