Mitsubishi Electric MELDAS C6 Instruction Manual page 97

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.
Check the TLM reference length.
To use gage block, etc., set the value of
the reference height
Position the tool to the reference point by
making return to reference point, etc.
Select measurement tool.
Turn on the machine operation board TLM
switch.
Move the tool to the measurement point by
making jog feed or manual handle feed.
Upon completion of measurement, specify
the tool offset number.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
(2) Tool length measurement II
START
search engine
2.3 (II). Tool Offset (M system)
Setting and display on the TOOL OFFSET
screen
Check axis specification parameter "#2015
tlml-" data of machine parameter.
(Set the value of the distance from the
reference point to table surface.)
Set # ( 0 ) DATA (
The data is displayed in SURFACE
# 0 =
The message TLM is displayed on the
TOOL OFFSET screen.
Dummy tool length data "parameter tlml" -
"#0" is displayed in the DATA (
The measurement value is displayed in the
DATA (
The current value of the measurement axis
is displayed under [MACHINE] Z.
Set the offset number in # (
the
The measurement data is displayed at the
position of the specified offset number.
I - 82
. ) and press the
INPUT
key.
.
) field in sequence.
INPUT key.
) field.
) and press