Mitsubishi Electric MELDAS C6 Instruction Manual page 446

Error No.
0110
0113
0138
0139
0141
0190
0191
Downloaded from ManualsNet.com
Details
Tape search execution
Automatic start is not possible as tape
search is being executed.
Thermal alarm
Automatic start is not possible because
a thermal alarm (Z53 TEMP. OVER) has
occurred.
Disabled start during absolute position
detection alarm
A start signal was input during an
absolute position detection alarm.
This check is performed on only the NC
axes. Thus, even if the alarms related to
the absolute position detection occurs
on the PLC axis, the start signal is
available.
Disabled start during zero point
initialization
A start signal was input while initializing
the absolute position detector's zero
point.
This check is performed on only the NC
axes. Thus, even if the PLC axis is under
the zero-point initializing state, the star
signal is available.
Start during MDI operation at other part
system disable
When using the multiple
specifications, the start signal was input in
the MDI mode while MDI operation was
being carried out with another
Automatic start disable
Automatic start is not possible because
the setup parameter setting enabled
state is entered.
Automatic start disable
Automatic start was attempted when
deleting/reading a file.
search engine
7. List of Alarms
7.2 Stop Codes
• Begin automatic start after the tape
search is completed.
• The NC controller temperature has
exceeded the specified temperature.
Take appropriate measures to cool the
unit.
• Reset the absolute position detection
alarm‚ and then input the start signal.
• Complete zero point initialization
before inputting the start signal.
• End the other part system's operation
before starting.
part system
part system.
• Refer to the instruction manual issued
by the machine maker.
• Carry out automatic start after the file
deleting/reading process is
completed.
IV - 30
Remedy