Handle Interruption; Outline; Interruptible Conditions - Mitsubishi Electric MELDAS C6 Instruction Manual

6.15 Handle Interruption

6.15.1 Outline

Section 6.14 explains automatic handle interruption, which enables the operator to interrupt movement
using the manual handle in automatic modes (memory, MDI).
(This is an optional function.)
X
1

6.15.2 Interruptible Conditions

(1) The automatic handle interrupt function allows you to interrupt the program manually by
(2) If automatic operation mode such as tape, memory, or MDI is being selected even when an
(3) If the axis is moved during dwell (G04) command processing by using automatic handle
(4) Automatic handle interruption is enabled even if automatic machine lock has been set. If
(5) This function is disabled for an axis to which the interlock signal has been input or an axis, the
Downloaded from ManualsNet.com
6. Operation Panel Switch Functions
Y
Z
Interrupt
10
100
G01 Z_F;
X_Y_;
X_Y_;
X_Y_;
selecting the manual handle mode in automatic mode selection (tape, memory, MDI, etc.).
However the interrupt cannot be generated from the manual handle when an automatic
reference point return command (G28, G29, G30), the thread cutting (G33), or the skip
command (G31) has been executed or when tapping in the tapping cycle.
automatic operation pause (including a block stop) is established, automatic handle interruption
is enabled.
interruption, the dwell count operation will stop. A check is made for that the axis movement has
been completed, then the dwell count operation continues.
manual machine lock has been set, the machine does not move; it only updates the POSITION
display. If manual machine lock has not been set, the machine moves by the interruption
distance by the manual handle and the POSITION display is updated.
interruption direction of which is the soft limit.
search engine
6.15 Handle Interruption
Handle feed
(Z axis)
Automatic feed
(X axis)
II - 24
Tool
Workpiece