Data Input/Output Using Flash Ata Card; Procedure To Use Flash Ata Card - Mitsubishi Electric MELDAS C6 Instruction Manual

9.3 Data Input/Output Using Flash ATA Card

The data can be collectively input/output or compared in ATA CARD IN/OUT screen under the user
PLC stop state.

9.3.1 Procedure to Use Flash ATA Card

(1) Stop the user PLC.
(2) Insert a flash ATA card to the slot.
(3) Call out ATA IN/OUT screen and select the maintenance data and its type as below.
Selecting the input/output maintenance data
(Note 1)
(Note 2)
(Note 3)
Downloaded from ManualsNet.com
9.3 Data Input/Output Using Flash ATA Card
To stop the user PLC, enter the emergency stop state by pressing the emergency stop button,
and set the rotary switch NCSYS to "1".
#( 10) ( 99)(
Refer to the
Maintenance
table below
data
3rd setting area
ALL1
ALL2
ALL3
Individual data No.
Blank
For independent data, if the data type No. is set to n, "n.MNT" will be the independent data
file name.
Refer to "9.1 Data Input/Output Function" for the data type.
Refer to Chapter 1 "2.7.6 Flash ATA Card I/F" for details of the flash ATA card
input/output.
search engine
9. Maintenance Functions
)
Type of input/output maintenance data
System data No.100 to 149
File data No.200 to 231
PLC program No.250, No.252 to 299
Individual data
(including No.150 to 199 and No.251)
All ALL1 to ALL3
III - 65
Extension
.AL1
.AL2
.AL3
.MNT
.ALL