(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
(Note 1) If the screen is changed back to the TOOL DATA screen after the characters are
(Note 2) If an axis having an error (reference point return incomplete axis, etc.) is selected, the
(Note 3) For a diameter command, the diameter value is written.
(Note 4) An error occurs in the following cases:
Downloaded from
ManualsNet.com
2. Screen Operation of A985GOT
(7) The data is automatically calculated and written.
(The data is written for the axis shown in highlighted characters.)
INPUT
Repeat the above steps for each tool.
highlighted, the characters will return to the usual display. Retry processing, beginning
with step (3) or (4).
characters will not be highlighted. An error message will appear.
For a radius command, the radius value is written.
• # ( 1) X (
• # ( 1) X ( 10.0) Z ( 35.0) ... The character was not highlighted although
In these cases the status is held, so reset correctly and then repress
search engine
2.3 (I). Tool Offset (L system)
) Z ( 35.0) ... The X axis measurement value was not set.
the X axis measurement value was set.
I - 56
INPUT
.