Mitsubishi Electric MELDAS C6 Instruction Manual page 159

(3) When the machining programs in the specified range are to be output
1) Data output is started.
2) The number and the contents of the
3) When
The output format is as follows:
(Note)
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
A group of programs can be output by specifying a range of program numbers. To specify the
range, set the largest and smallest numbers of the machining programs to be output in the data
setting area. The machining programs in the specified range are output sequentially in order of
their program numbers.
Specify the data type, and then
the smallest and largest program
numbers.
(Example)
To output program numbers
O9000 to O9999, specify:
# ( 1 ) DATA ( 9 0 0 0 )
( 9 9 9 9 )
Press the key.
INPUT
machining program being output are
displayed in the OUTPUT DATA display
area.
all the specified
programs are output, data set in the data
setting area disappears and instead
message "DATA OUT COMPLETE" is
displayed.
1. If the number specified as the smallest number is not found, output starts with the
machining program with the number nearest to that number.
Likewise, if the number specified as the largest number is not found, output ends with
the machining program with the number nearest to that largest number.
2. Specify the smallest number first, then the largest number. If the numbers are specified
reversely, program error E01 SETTING ERROR occurs.
search engine
2.6 Data In/Out
machining
I - 144