Mitsubishi Electric MELDAS C6 Instruction Manual page 114

<AUTO CORNER OVR.> (Automatic corner override)
#
8007 OVERRIDE
8008 MAX ANGLE
8009 DSC. ZONE
<T-TIP OFFSET> (Wear data input)
#
8010 ABS. MAX.
(For L system only)
8011 INC. MAX.
(For L system only)
<FIXED C.> (Fixed cycle)
#
8012 G73n
(For M system only)
8013 G83n
8014 CDZ-VALE
(For L system only)
8015 CDZ-ANGLE
(For L system only)
8016 G71 MINIMUM
(For L system only)
8017 DELTA-D
(For L system only)
8018 G84/G74n
(M system dedicated)
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Name
Set the override value for the automatic corner
override.
Set the max. corner opening angle where
deceleration should start automatically.
Deceleration will not occur if the angle is larger
than this value.
Set the position where deceleration starts at the
corner.
Designate the distance from the corner at which
deceleration should start.
Name
Set the max. value when inputting the tool wear
compensation amount.
Values exceeding this setting value cannot be input.
Set the max. value when inputting the tool wear
compensation amount in the incremental mode.
Name
Set the return amount for G73 (step cycle).
Set the return amount for G83 (deep hole drilling
cycle).
Set the cutting amount for the thread in G76 and 78
(thread cutting cycle).
Set the cutting angle for the thread in G76 and 78
(thread cutting cycle).
Set the min. value for the final cutting amount in
G71 and 72 (rough cutting cycle).
If the final cutting amount is smaller than this value,
the final cut will not be carried out.
Set the change amount for the command cutting
amount D in G71 and 72 (rough cutting cycle).
Each cutting amount will be the value obtained by
this value added to or subtracted from command D.
Thus, the amount can be changed for each cut.
Set the return amount "m" for the G84/G74 pecking
tap cycle.
(Note) The normal tap cycle will take place when
search engine
2.4 Parameters
Contents
Contents
Contents
"0" is set.
I - 99
Setting range (unit)
0 to 100 (%)
0 to 180 (°)
0 to 99999.99 (mm)
Setting range (unit)
0 to 99.999 (mm)
0 to 99.999 (mm)
Setting range (unit)
0 to 99999.999 (mm)
0 to 99999.999 (mm)
0 to 127
(unit:0.1 lead)
0 to 89 (°)
0 to 99.999 (mm)
0 to 99.999 (mm)
0 to 999.999 (mm)