Appendix 2. Registering And Editing Fixed Cycle Programs; Parameter For Fixed Cycle Operation; Inputting A Fixed Cycle Program; Outputting A Fixed Cycle Program - Mitsubishi Electric MELDAS C6 Instruction Manual

Appendix 2. Registering and Editing Fixed Cycle Programs

The fixed cycle subprogram can be input, output and edited.
CAUTION
Do not change the fixed cycle program without prior consent from the machine maker.

2.1 Parameter for Fixed Cycle Operation

The fixed cycle subprogram data is input, output and edited with the DATA IN/OUT screen and EDIT
screen in the same manner as the normal user-created machining program. However, a parameter
must be set beforehand. Set parameter "1166 fixpro" on the Basic Specification Parameter screen to "1"
before starting inputting, outputting and editing operations. When this parameter is valid, the DATA
IN/OUT screen and EDIT screen will become dedicated for the fixed cycle control subprogram. Only the
fixed cycle programs will appear in the program list. Thus, when done working with the fixed cycle
program, set this parameter to "0".
(Note) Parameter "#1166 fixpro" will be set to 0 when the power is turned OFF.

2.2 Inputting a Fixed Cycle Program

The fixed cycle program is input on the DATA IN/OUT screen. Confirm that the parameter "#1166 fixpro"
for fixed cycle operations is valid.
The operation methods are the same as the user machining programs.
It is handier to input the data in succession.
After registering, confirm that the program has been correctly registered in the program list and EDIT
screen.

2.3 Outputting a Fixed Cycle Program

The fixed cycle program is output on the DATA IN/OUT screen. Confirm that the parameter "#1166
fixpro" for fixed cycle operations is valid.
The operation methods are the same as the user machining programs. The registered fixed cycle
program can be output one by one, or all programs output as a batch.
To output all programs in a batch, or to input the programs, all programs can be input in succession with
one operation.
After outputting, always compare the programs to confirm that there are no data output mistakes.

2.4 Deleting a Fixed Cycle Program

The fixed cycle program is deleted on the DATA IN/OUT screen. Confirm that the parameter "#1166
fixpro" for fixed cycle operations is valid.
The operation methods are the same as the user machining programs.
Downloaded from ManualsNet.com
2. Registering and Editing Fixed Cycle Programs
2.1 Parameter for Fixed Cycle Operation
search engine
IV - 2