Interruption Effective Axis; Axis Movement Speed Resulting From Interruption - Mitsubishi Electric MELDAS C6 Instruction Manual

6.15.3 Interruption Effective Axis

(1) Automatic handle interruption is enabled only for axes to which manual handle axis selection
(2) Automatic handle interruption is enabled for a maximum of three axes. (The number of axes is

6.15.4 Axis Movement Speed Resulting from Interruption

(1) The movement speed of the axis for which handle interruption is executed, may exceed the
(2) The movement speed of the axis for which handle interruption is executed, may exceed the
(3) If, during automatic start, manual handle interruption is executed, in the same direction, for the
(4) If an attempt is made to execute interruption at a speed exceeding the clamp speed, the
(5) The handle scale factor depends on the selected input of the manual handle/step scale factor.
Downloaded from ManualsNet.com
6. Operation Panel Switch Functions
has been input.
restricted by the number of handles.)
rapid traverse feed rate during rapid traverse feed command (G00) processing in automatic
start. To prevent this, clamp the axis. (The movement speed equals Automatic-start movement
speed + Speed resulting from manual handle interruption.)
cutting feed speed during cutting feed command (G01, G02, G03) processing in automatic start.
To prevent this, clamp the axis. (The movement speed equals Automatic start movement speed
+ Speed resulting from manual handle interruption.)
axis that is moving at an external decelerating speed, the axis movement speed may exceed
the external decelerating speed. To prevent this, clamp the axis. (The movement speed equals
Automatic start movement speed + Speed resulting from manual handle interruption.)
reading on the handle scale does not match the distance of interruption.
search engine
6.15 Handle Interruption
II - 25