Mitsubishi Electric MELDAS C6 Instruction Manual page 143

(3) Sequence number, block number search
The operation procedure is described below.
(1)
Press the menu key
1) The
Set the called program number,
(2)
sequence number, and block
number.
(Example)
O (
(3)
Press the
1) The message SEARCH EXECUTION is
2) A search for a given N number is started
3) The cursor is displayed at the top of the
4) At normal completion of search, display
(Note 1) When a given N number is not found, an "NB NOT FOUND" message is displayed.
(Note 2) If a given program number is not found, a "PROG NOT FOUND" message is displayed.
(Note 3) The sequence number can be specified in a maximum of five digits.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Specify the called program number, sequence number, and block number in the setting area. If
only digits are set in N ( ), a sequence number search is made. (If an alphabetic character or
symbol is contained, a character string search is made.) To search the top of a program,
specify only the program number. To search an already displayed program on the screen for a
given sequence number, program number specification may be omitted.
SEARCH
setting area for
displayed.
) N ( 6) - ( )
key.
INPUT
displayed during searching.
at the top of the specified program. The
program is displayed starting at the block
containing the found N number. However,
for the program already displayed on the
screen, a search for the specified N
number is started at the displayed portion.
found block.
of the setting area disappears and
SEARCH menu display is restored to
normal mode from reverse mode.
search engine
2.5 Program
.
SEARCH is
I - 128
SMALL
SMALL
SMALL
SMALL