5.6 (D) Operation Command And Frequency Command - Mitsubishi Electric FR-F800 Series Instruction Manual

5.6
(D) Operation command and frequency command
To select the operation mode
To start up the inverter in Network operation
mode at power-ON
To select the command source during
communication operation
To prevent the motor from rotating reversely
To set the frequency using pulse train input
To perform JOG (inching) operation
To control the frequency with combinations of
terminals
5.6.1 Operation mode selection
Select the operation mode of the inverter.
The mode can be changed among operations using external signals (External operation), operation by the operation panel or
the parameter unit (PU operation), combined operation of PU operation and External operation (External/PU combined
operation), and Network operation (when RS-485 terminals or a communication option is used).
Pr.
79
Operation mode selection 0
D000
The following table lists valid and invalid commands in each operation mode.
240
5. PARAMETERS

5.6 (D) Operation command and frequency command

Downloaded from ManualsNet.com
Purpose
Operation mode selection P.D000
Communication startup
mode selection
Operation and speed
command sources during
communication operation,
command source
selection
Reverse rotation
prevention selection
Pulse train input
JOG operation
Multi-speed operation
Name Initial value
search engine
Parameter to set
P.D000, P.D001
P.D010 to P.D013
P.D020
P.D100, P.D101,
P.D110, P.D111
P.D200, P.F002
P.D300 to P.D315
Setting range
0 to 4, 6, 7 Selects the operation mode.
Refer to page
Pr.79 240
Pr.79, Pr.340 250
Pr.338, Pr.339,
251
Pr.550, Pr.551
Pr.78 257
Pr.291, Pr.384 to
258
Pr.386
Pr.15, Pr.16 261
Pr.28, Pr.4 to
Pr.6, Pr.24 to
263
Pr.27, Pr.232 to
Pr.239
Description