Mitsubishi Electric MELDAS C6 Instruction Manual page 477

Error No.
E10
E11
E12
E13
E14
E15
E16
E17
E18
E20
E21
E22
Downloaded from ManualsNet.com
7.9 Operation Messages on Setting Display Unit
Error message
×
MEMORY OVER
∆
PROG. No. DUPLI
×
FILE ENTRY
OVER
∆
NB NOT FOUND
∆
PROG. NOT
FOUND
×
EDIT LOCK B
×
EDIT LOCK C
×
PARITY H ERR
×
PARITY V ERR
×
OVER RUN ERR
×
PROGRAM
RUNNING
×
CODE CHANGE
ERR
search engine
7. List of Alarms
• The program cannot be written because the memory capacity
is exceeded.
This error occurs when the MDI data setting on the MDI screen
exceeds 500 characters‚ or when saving MDl‚ editing or
making a program on the edit screen‚ input on the data
input/output screen‚ program copy‚ etc.
• When registering a machining program in the memory‚ a
program with the same No. as the designated program No.
was found in the memory. Refer to the program file to find a
program No. not being used‚ and reset the program No.
This error occurs during MDI registration in the MDI screen or
during creation of a program in the edit screen.
• When registering a machining program in the memory‚ the No.
of programs determined in the specifications is exceeded‚
preventing registration.
This error occurs during MDI registration in the MDI screen‚
creation of a program in the edit screen‚ data input in the data
input/output screen‚ and program copy.
• The block with the designated sequence No. or block No. does
not exist in the designated program.
• The designated program is not found in the memory.
• The corresponding program No. was not found with search of
tape memory during graphic check.
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program B and C was attempted.
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program B was attempted.
• A parity H error was detected during data input‚ etc.
Check the paper tape or input device. This error may occur if
the paper tape is dirtied with oil‚ etc.
• A parity V error was detected during data input. Check the
paper tape to see whether the number of characters in the
significant information section of a block is odd.
Also check the state (cable wiring‚ noise measures‚ etc.) of the
connected equipment.
• The control method using the DC codes‚ etc.‚ for the input/output
operation is incorrect.
Check the settings of the input/output unit parameters‚ and the
settings on the input/output unit side‚ and reset if necessary.
• Deletion of a machining program was attempted during
operation.
• Search was attempted during operation.
• Change of data such as parameters was attempted during
operation.
• Start of graphic check was attempted during operation.
• There was an illegal code on the paper tape.
IV - 61
Details