Setting Tool Offset Data; Erasing The Tool Offset Data - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (II). Tool Offset
(M system)" for M system.

2.3.1.1 Setting Tool Offset Data

(1) To set the tool offset data, set the offset memory No. in # ( ), and set the offset data in the
setting areas corresponding to wear data, tool length data and tool nose data. Then press the
(2) If the
offset data set in the corresponding offset memory No. position is displayed. The offset memory
No. in # ( ) of the setting area is incremented by 1, and the contents in DATA ( ) disappear.
The No. is not incremented when parameter "#1124 ofsfix" is 1.
(3) If tool offset data and offset memory Nos. other than those in the display are set, the screen
changes to the screen corresponding to the set offset memory No. when the
first pressed. The offset memory is displayed when the
(4) By pressing the
continuously incremented or decremented by one.
(5) Tool offset data setting range
(Note) When parameter "#1019 dia" (diameter command) is set to 0, set the radius. When it is

2.3.1.2 Erasing the Tool Offset Data

(1) Erasing the display screen units
Ten sets of tool offset data units are displayed on one screen. To set all the displayed offset
data to 0, press the
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
key.
INPUT
INPUT
key is pressed after the offset memory No. and tool offset data are set, the tool
and
Screen Item
TOOL TIP X, Z, C
OFFSET
TOOL DATA X, Z, C
NOSE-R R
r
P
set to 1, set the diameter.
SHIFT key, the
search engine
2.3 (I). Tool Offset (L system)
keys, the offset memory No. displayed in # (
Function
Tool wear
Tool length offset
Tool radius (nose R)
Tool radius (nose R) wear
Tool nose point
CAN
key, and finally the
C.B
I - 48
INPUT
INPUT
is pressed again.
Setting range (unit)
± 99.999
± 999.999
0~99.999
0~99.999
0~8
INPUT
key.
key is
) can be
(mm)
(mm)
(mm)
(mm)