(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
Press the
2.3.6.3 Tool Registration in the Spindle, Standby and Indexing Areas
These commands are used to change the display data when the tool No. set in the magazine pot
differs with the displayed tool No.
Set to USAGE
Set "N0" in MG (
"8" in TOOL (
Press the
(Note) Although the title display in the upper portion of the screen differs according to the maker,
Downloaded from
ManualsNet.com
2. Screen Operation of A985GOT
2.3 (I). Tool Offset (L system)
INPUT
key.
MG (N0) TOOL (
), and
).
INPUT
key.
the data is always set by an input of N0.
search engine
The tool No. and data in D appear in the designated
magazine pot, and the magazine No. in MG (
incremented by 1. The data in the other (
appears.
When a No. other than the magazine No. in the data
display area is set, the screen changes as follows:
INPUT
When the
key is pressed the 1st time, the
screen corresponding to the magazine No. appears.
INPUT
When the
is pressed the 2nd time, the data
set in the data area appears.
Refer to the instruction manual issued by the
(Note)
maker for data on the function and purpose
of the data in D.
)
"8" appears under USAGE in the data display area,
and the display in the data setting area changes to
MG (N1).
I - 73
) is
) dis-