Mitsubishi Electric MELDAS C6 Instruction Manual page 254

(2) Using the tool position as the display range center
For example, assume that the tool
mark is not in the screen center,
and a drawing is made as shown
at the right.
Press the keys
1) The tool mark appears in the
2) If the message TRACE EXECU-
(Example) Changing the scale and display position
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
CAN
SHIFT and
C.B
screen center.
TION appears, consecutive
drawing is made.
CAN
SHIFT + function
(Note)
C.B
This function displays
current machine position in the
screen center.
1) This operation cannot be carried out while any one of SCALE, GRF MODE, ROTATION, or
CHECK SEARCH is valid.
2) The machine position is not moved in program check mode, even if drawing is carried out.
Therefore, the tool center cannot be displayed in the center of the screen, even with the
above key operation.
3) However, both the drawing and machine position move in the trace mode, so the tool center
can be displayed in the center of the screen with the above key operation.
simultaneously
To enlarge the graphics (shown at the
right) in the screen center, carry out the
following operations:
search engine
2.8 Graphics
.
the
I - 239
TRACE EXECUTION
TRACE EXECUTION
TRACE EXECUTION