Mitsubishi Electric MELDAS C6 Instruction Manual page 115

<PRECISION> (High precision control)
#
8019 R COMP
8020 DCC. ANGLE
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Item
Set up a compensation factor for reducing a control
error in the reduction of a corner roundness and
arch radius.
Indicate a maximum control error (mm) in
parentheses.
The larger the setup value, the smaller the
theoretical error will be. However, since the speed at
the corner goes down, the cycle time is extended.
Set up the minimum value of an angle (external
angle) that should be assumed to be a corner.
When an inter-block angle (external angle) in
high-precision mode is larger than the set value, it
is determined as a corner and the speed goes
down to sharpen the edge.
(Note) If "0" is set, it will be handled as 5 degress.
The standard setting value is "0".
search engine
2.4 Parameters
Contents
If the set value is smaller
θ
θ
than , the speed goes down
to optimize the corner.
I - 100
Setup range (unit)
0 to 99 (%)
0 to 30 (°)
0: The angle will be
5 degress.