Mitsubishi Electric MELDAS C6 Instruction Manual page 26

(1) Operation status mode
Position
(Note 1)
(1) Alarms/Messages
In the message display area, the alarm or warning message that has the highest priority among
the alarms currently occurs under the current part system.
Communication
error
KEY
OPERATION
INVALID
When some error occurs with the communication with NC, a dialogue box will appear.
Refer to "Chapter IV Appendices" for details of the other alarms or messages.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
2.1 Setting and Display Unit Operation
Display symbol
ST1 EMG
RST
LSK
HLD
STP
ST2 mm
in.
ST3 ABS
INC
ST4 G40
G41
G42
ST5 G54
G59
ST6
SB1
SB2
:
ST7 fix
ST8
denotes blank display.
Message Details of message
An error has occurred in the
communication with the NC.
The NC-dedicated display unit or
display unit other than touch
panel is connected, and key
inputs from the menu section or
keyboard section are invalid.
Inputs from the display unit other
than touch panel are valid in this
case.
search engine
During emergency stop
During reset
When paper tape reader is in label skip state
During feed hold stop
During single block stop
Normal operation state other than the above
Metric command
Inch command
Absolute command mode G90
Incremental command mode G91
Tool radius compensation cancel state
During tool radius compensation (left)
During tool radius compensation (right)
Selection of the workpiece coordinate is indicated.
This indicates that subprogram is not executed.
Machining program execution is controlled according to subprogram
data. Each value indicates the subprogram depth.
Fixed cycle is being executed.
Fixed cycle is not executed.
• Check the connection between the NC
• Check the NC and GOT network
The key inputs become valid by following
operations.
• Disconnect the NC-dedicated display
• Press the OPERATE menu.
I - 11
Explanation
Remedy
and GOT.
(Cable connection, noise, etc.)
settings.
unit.