Mitsubishi Electric MELDAS C6 Instruction Manual page 481

Error No.
E201
E301
E302
E311
E312
E313
E314
E315
E316
E317
E318
E319
Downloaded from ManualsNet.com
7.9 Operation Messages on Setting Display Unit
Error message
×
UNIT NOT EQUIP
×
CONNECT
ERROR
×
LOGIN ERROR
×
DOWNLOAD ERR
×
UPLOAD ERROR
×
NO FILE
×
FILE DUPLICATE
×
FILE WRITE ERR
×
FILE READ ERR
×
MEMORY OVER
×
OVER FLOW ERR
×
DIRECTORY ERR
search engine
7. List of Alarms
• The analog output unit is not mounted.
• Confirm the remote l/O unit.
• Prepare a unit having analog output.
• Check the connection (power and signal wires)
• Unit defect (replace unit)
• The socket connection failed during Ethernet communication.
• If the host address is illegal or the port No. is incorrect, set
correctly.
• Log in failed during Ethernet communication.
• Check the user name and password.
• Reading of a file on the host side failed during Ethernet
communication.
• Writing of a file on the host side failed during Ethernet
communication.
• The file designated with the host reception (host → IC)
operation was not found on the host side during Ethernet
communication.
• The file designated with the host transmission (IC → host)
operation was not found in the IC card during Ethernet
communication.
• The file name to be registered with the host reception (host →
IC) operation was found in the IC card during Ethernet
communication.
• The file name to be registered with the host transmission (IC →
host) operation was found in the host during Ethernet
communication.
• Writing to the IC card failed during Ethernet communication.
• Reading of an IC cared file failed during Ethernet
communication.
• The IC card memory is full.
• The NC memory is full.
• There are too many files in the host directory.
• Movement of the directory failed.
IV - 65
Details