Mitsubishi Electric MELDAS C6 Instruction Manual page 122

#
9109 DC CODE
PARITY
9111 DC2/DC4
OUTPUT
9112 CR OUTPUT
9113 EIA OUTPUT
9114 FEED CHR.
9115 PARITY V
9116 TIME-OUT (sec)
9117 DR OFF
9118 DATA ASCII
9119 INPUT FORM
9121 EIA CODE
9122
9123
9124
9125
9126
9127
9128
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Items
Specify the DC code when the DC code method is selected.
0: No parity to DC code (DC3=13H)
1: DC code with parity (DC3=93H)
Specify the DC code handling when outputting data to the output device.
0: None
1: Yes
2: None
3: Yes
Specify whether to insert the <CR> code just before the EOB (L/F) code
during output.
0: Do not add
1: Add
0: Output with ISO code.
1: Output with EIA code.
Specify the length of the tape feed to be output at the start and end of the
data during tape output.
The setting range is 0 to 999 characters.
Specify whether to check the parity of the No. of characters in block
during data input.
0: Do not perform parity V check
1: Perform parity V check
The No. of characters is factory-set so that the check is valid at all times.
Set the time out time to detect an interruption in communication.
The setting range is 0 to 30 [s].
The time out is not checked when 0 is set, so the waiting time will be
infinite.
The screens in the setup/maintenance tool cannot be changed during the
waiting time. Set this time to 10 as the standard.
Specify whether to check the DR data during data input/output.
0: DR valid
1: DR invalid
0: Output in ISO/EIA code (Depends on whether #9113, #9213,
1: Output in ASCII code
Specify the method used during input (compare).
0: Standard input (Data is handled as significant information from
1: The EOB input in succession after the first EOB in the data is
[
When outputting with the EIA codes, special ISO codes not included in
EIA can be output with alternate codes.
]
For each special code, designate a code (as a hexadecimal) that is not
#
duplicated with existing EIA codes.
*
=
:
$
!
search engine
2.4 Parameters
Details
DC2 DC4
None
None
Yes
Yes
#9313, #9413, or #9513 EIA output parameter is set up)
first EOB)
skipped until data other than EOB is input.
I - 107