I/O Parameters; I/O Base Param - Mitsubishi Electric MELDAS C6 Instruction Manual

2.4.3 I/O Parameters

Pressing the menu key
There are basically two types of input/output parameters which must be set when inputting,
outputting or referring to data, or when performing tape operation. One type is the parameters
related to the input/output device. The baud rate, etc., is set according to each device. Up to five
types of input/output devices can be registered. The other type of input/output parameters is the I/O
base parameters which determine which device is connected to which channel per input/output
application.

2.4.3.1 I/O Base Param

<I/O>
DATA IN
DATA OUT
NC
RUNNING
MACRO
PRINT
PLC IN/OUT
REMOTE
PROG IN
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
I/O PARA
#
<PORT No.>
Specify the board No. to which the
serial input/output device is
connected for each application.
Only 0 is valid.
9001 Specify the port for inputting the
data such as machine program and
parameters.
9003 Specify the port for outputting the
data such as machine program and
parameters.
9005 Specify the input port for running
with the tape mode.
9007 Specify the output port for the user
macro DPRINT command.
9009 Specify the port for inputting/
outputting various data with PLC.
9011 Not used.
search engine
2.4 Parameters
displays the I/O BASE PARAM screen.
REMOTE PROG IN 9 0 1 1 0
#
9002 Specify the No. of the device that
9004 Specify the No. of the device that
9006 Specify the No. of the device to be
9008 Specify the No. of the device for the
9010 Specify the No. of the device for the
9012 Not used.
I - 105
9 0 1 2 0 R I N
<DEV. No.> <DEV. NAME>
Set the input/output device No. for
each application.
The device Nos. are 0 to 4 and
correspond to the input/output
device parameters.
The device name set in the input/
output device parameter is also
displayed for identification.
inputs the data.
outputs the data.
run with the tape mode.
DPRINT command.
PLC input/output.
7