Mitsubishi Electric MELDAS C6 Instruction Manual page 182

<Output format>
The files in the flash ATA card are output with the following format.
The end of the line is "CR+LR" instead of ";".
"%" is output at the end of the file.
Data type
Machining
program
(Note 1)
Tool data
Parameter
data
Auxiliary axis
parameter
data
(Note 1) One file contains one machining program.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
O1000 (TEST PROGRAM) CRLF : Header "0" + "program No." + "(" + "comment" + ")"
N010G28X0. CRLF
N200G00X-100. CRLF
:
:
M02 CRLF
%
$1 CRLF
G10L10P1R100. CRLF
G10L10P2R123. CRLF
:
:
G10L2P6X0.000Z0.000 CRLF
%
PARA200 ( ) CRLF
N1 P74 CRLF
N2 P00 CRLF
N3 P00 CRLF
:
:
%
PARA200 ( ) CRLF
N50001A1P0000 CRLF
N50002A1P0000 CRLF
N3 P00 CRLF
:
:
:
%
Normally eight or less digits are set as the file name in the same manner as the machining program
number saved in the memory.
A random "eight or less alphanumeric characters, three or less character extension" can be used for the
file name.
Note that if an extension unique to the above data ("OFS", "PRM", etc.) is used for the extension, an
error will occur.
If the file name contains characters other than numbers or an extension, the machining program No. must
be designated when the file is to be saved in the NC memory again.
search engine
2.6 Data In/Out
Output example
Machining
:
program
: Part system selection
Tool data
:
: Header "PARA100" or "PARA200"
Parameter
:
data
: Header "PARA100" or "PARA200"
Parameter
:
data
I - 167
O1000 (TESTPRO) ...
Comment added when
machining program was
created
Program No.
G10 L10 P1 R100.
Data
Tool No.
L10:Tool length/
L11:Wear
N2 P00
Data
Parameter No.
N50001 P00
Data
Parameter No.