Tool Registration Data Clear; Manual Numeric Command Operation On The Tool Registration Screen (M, T) - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.

2.3.2.4 Tool Registration Data Clear

Set "CL" in MG (
Press the

2.3.2.5 Manual Numeric Command Operation on the TOOL REGISTRATION Screen (M, T)

To execute a manual numeric command on the TOOL REGISTRATION screen, first change the
mode from usual data setting to manual numeric command. The M and T commands can be
executed by screen operation in manual numeric command mode.
(1) Changing the mode from usual data setting to manual numeric command
Set
pair of the setting field.
1) This operation is necessary regardless of
Press the
changes to manual numeric command.
1) Data is cleared from the setting field. The
(2) Execution of the manual numeric command ... Execute this after operation (1) above.
(Note) The manual numeric command operation is the same as the operation for the POSITION
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
).
INPUT
key.
In the usual data setting mode, the cursor is
displayed in the data setting field. It is not
displayed in manual numeric command mode. By
checking this difference, make sure that the mode
has changed. Change the mode by the following
operations:
M (Manual) in the first parenthesis
the command (M, T).
INPUT key. The mode
cursor is also cleared from the screen.
1) Press the address key corresponding to the command. The corresponding command value
display field is highlighted, and the manual numeric command input mode is activated. To
execute the tool function, input
2) Input the specified numerics from keys.
3) Press the INPUT key. The command is executed.
screen. See "2.2.1.3 Manual Numerical Value Command" in 'POSITION' of 'MONITOR'
screen for details.
search engine
2.3 (II). Tool Offset (M system)
T . To execute the miscellaneous function, input
I - 86
All data displayed in HEAD, NEXT
1 to NEXT 3, INDEX, and MG1 to
MGn is cleared.
M .