(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
2.3.2 Tool Length Data
The TOOL DATA screen will appear when the menu key
Set the tool length in respect to the programmed base position of each tool used.
When the tool compensation No. is designated by the tool command (T command), compensation
is carried out matching the wear data of the previous screen. Generally, the programmed base point
position is either the tool rest center position or the base tool nose position.
(1) Tool rest center position
(2) Base tool nose position
Downloaded from
ManualsNet.com
2. Screen Operation of A985GOT
2.3 (I). Tool Offset (L system)
Base position
search engine
T-DATA
is pressed.
Base position
Data
X
X axis tool length compensation
Z
Z axis tool length compensation
Additional axis tool length
C
compensation
Same value as on the
MACHINE
MONITOR screen.
Base tool
I - 50
Function