Control Parameters - Mitsubishi Electric MELDAS C6 Instruction Manual

2.4.2.2 Control Parameters

#
8101 MACRO SINGLE
8102 COLL. ALM OFF
8103 COLL. CHK OFF
8105 EDIT LOCK B
8106 G46 NO
REV-ERR
(For L system only)
8107 R OMPENSATION
8108 R COMP Select
8109 HOST LINK
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Items
Select the control of the blocks where the user
macro command continues.
0: Do not stop while macro block continues.
1: Stop every block during signal block
Select the interference (bite) control to the workpiece
from the tool diameter during tool radius compensa-
tion and nose R offset.
0: An alarm is output and operation stops
1: Changes the path to avoid interference.
Select the interference (bite) control to the
workpiece from the tool diameter during tool radius
compensation and nose R offset.
0: Performs interference check
1: Does not perform interference check
Select the edit lock for program Nos. 8000 to 9999.
0: Program can be edited.
1: Editing of above program is prohibited.
Select the control for compensation direction
reversal in G46 (Nose R compensation).
0: An alarm occurs and the operation stops
1: The compensation direction is maintained
Not used.
Not used.
Not used.
search engine
2.4 Parameters
R COMPENSATION 0
R COMP Select 0
HOST LINK 0
Details
operation.
when an interference is judged.
when the compensation
direction reverses
(G41 G42, G42 G41).
as before without an alarm occurring when
the compensation direction reverses.
I - 101
Setting range (unit)
0/1
0/1
0/1
0/1
0/1
0
0
0