Mitsubishi Electric MELDAS C6 Instruction Manual page 105

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.
FORM
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
2.3 (II). Tool Offset (M system)
Display item
a. Tool life control mode
0: Use time
1: Mount count
2: Work count
b. Tool radius compensation data format
0: Compensation number
1: Addition compensation mode
2: Direct compensation mode
c. Tool length compensation data format
0: Compensation number
1: Addition compensation amount
2: Direct compensation amount
The functions are the same as in b. above.
search engine
Explanation
Tool life control mode
Tool radius compensation data format
Tool length compensation data format
controlled by the time during which cutting feed
is performed.
Controlled by the number of times the tool is
used as a single tool.
Work count
The work count is made whenever a rapid
traverse feed (G00 etc.) command is replaced
by a cutting feed command (G01, G02, G03,
etc.).
However, rapid traverse feed or cutting feed
commands inducing no movement are ignored.
Compensation data in tool data is handled as
compensation number. It is replaced with the
compensation number commanded in a
machining program for compensation.
Compensation data in tool data is handled as
addition compensation amount. It is added to
the compensation amount indicated by the
compensation number commanded in a
machining program for compensation.
Compensation data in tool data is handled as
direct compensation amount. It is replaced with
the compensation amount indicated by the
compensation number commanded in a
machining program for compensation.
I - 90
Setting range