Deleting Tool Registration Data; Manual Numerical Command Operation (M, T) On The Tool Registration Screen - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (II). Tool Offset
(M system)" for M system.

2.3.6.4 Deleting Tool Registration Data

Set CL in MG (
Press the
2.3.6.5 Manual Numerical Command Operation (M, T) on the TOOL REGISTRATION
To carry out manual numerical commands on the TOOL REGISTRATION screen, the mode must
first be changed from the normal data setting mode to the manual numerical command mode. M
and T commands can be executed by screen operation in the manual numerical command mode.
(1) Changing from the normal data setting mode
Set
parentheses in the setting area.
1) This operation is the same for M or T
commands.
Press the
changes to the manual numerical
command mode.
1) The data in the setting area is cleared, and
the cursor disappears from the screen.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
).
INPUT key.
Screen
to the manual numerical command mode
A cursor appears in the data setting area in
the normal data setting mode, but a cursor
does not appear in the manual numerical command
mode.
Confirm that the mode has changed over by
checking this difference. The operation is as follows:
M (manual) in the first set of
INPUT
key. The mode
search engine
2.3 (I). Tool Offset (L system)
I - 74
All data displayed in USAGE and
MG1 to MGn is cleared to 0.